A. MATERIAL:
YOU ONLY NEED A PIECE OF PAPER (SQUARE), YOUR HANDS AND A LOT OF PATIENCE
B. STEPS:
1. MAKE A SQUARE (FOLD THE PAPER FORMING A TRIANGLE AND CUT UP THE PAPER YOU DON'T NEED)
2. FOLD THE SQUARE INTO 2 EQUAL HALVES, YOU WILL GET A TRIANGLE.
3. REPEAT STEP 2 TO MARK THE 2 HALVES. THEN, UNFOLD IT.
4. MAKE A TRIANGLE ON EACH SIDE (USING THE CREASE MADE IN STEP 3 AS THE CENTRE). IF YOU DO IT RIGHT, YOU'LL GET A SQUARE.
5. TAKE THE FLAP ON THE LEFT END OF THE SQUARE AND FOLD IT TOWARDS THE CENTRE. REPEAT THIS STEP WITH THE RIGHT FLAP. (IF YOU DO IT RIGHT, YOU'LL GET A DIAMOND). THEN, UNDO THIS STEP.
6. OPEN THE MODEL AND USE THE CREASES MADE IN STEPS 4 AND 5 TO MAKE A DIAMOND. YOU HAVE TO FOLD THE TRIANGLES MARKED ON EACH SIDE INTO THE MODEL.
7. FOLD THE MODEL IN HALF AND YOU WILL GET 3 SLAPS.
8. TAKE THE UPPER FLAP AND FOLD IT TO THE LEFT (FORMING A SMALL TRIANGLE 0N THE INFERIOR PART OF THE MODEL). THEN, REPEAT THIS STEP WITH THE FLAP AT THE BACK.
9. FOLD THE RESULTING FLAPS TO THE OPPOSITE SIDE (THESE WILL BE THE WINGS)
10. NOW, WE ARE GOING TO MAKE THE BODY AND THE TAIL OF OUR DOVE. FIRST, LET'S MARK THE TWO SIDES OF THE MODEL THAT WILL GO INSIDE OUR DOVE. HOW? FIRST, FOLD ONE SIDE OF THE MODEL TO THE LEFT AND THEN FOLD IT TO THE RIGHT.
11. UNDO STEP 10. OPEN THE MODEL AND USE THE CREASES MADE IN STEP 10 TO FOLD THAT PART INTO THE MODEL.
12. NEXT, FOLD THE WINGS UP
13. NOW, WE ARE GOING TO MAKE THE BEAK OF OUR DOVE. FIRST, LET'S MARK THE TWO SIDES OF THE BEAK THAT WILL GO INSIDE THE MODEL. WE WILL FOLD THE BEAK TO THE LEFT AND THEN TO THE RIGHT. FINALLY, WE WILL USE THE RESULTING CREASES TO PUT THAT PART INTO OUR MODEL.
14. AND IT IS DONE 
Entradas
No hay comentarios:
Publicar un comentario